Gear position sensor to suit our sequential shifters.
This sensor uses a modern hall effect it needs a 5v supply and will output a voltage between 0-5v depending on the position of the magnet inside the shifter. This magnet was factory fitted.
You cannot read the position of the sensor with resistance on a multimeter you will need to use the voltage setting with a 5v supply connected to the sensor.
Wiring colours are :
White/blue or Green = Ground
White/Yellow or orange = 5V supply in
White/White = Signal out
Any voltage over 5.5 V will break the sensor.
If you use this to read gear position on a digital dash you will also need an input from the reverse switch on the gearbox as 1st and reverse are on the same position on this sensor.